How to reset and add a UK Wireless Siren to the Gen 2

     


To reset a Gen 2 UK wirless siren

1. First turn the power switch 'On' located at the back of the siren. It will flash and beep once.
2. Hold down the 'Set' button down for 3 seconds until the siren light stays on and immediately let go of the 'Set' button
3. Hold down the 'Set' button again and the siren will flash and beep 4 times
4. The siren has now been reset.
   Click here to watch video: How to reset a UK Siren

How to add a UK Wireless Siren to the Gen 2

1. Select the 'Security' icon on the Gen 2 alarm panel and enter your 'System' code
2. Select the 'Alarm' icon  and ensure that 'Local Alarm', 'Siren Alarm' and 'Delay beep' have been turned 'On' then select the back button on the upper right side.
3. Select the 'Connection' icon on the main screen and enter your 'System' code
4. Select the 'Siren' icon   You will see a message that says 'Please make sure the siren is ready for pairing'
5. Turn the Siren switch to the 'On' position, the siren will flash and beep once.
6. Hold the 'Set' button down for 3 seconds and the siren will beep three times and the siren light will stay on
7. Select 'Ok' on the alarm panel and the siren will flash and beep twices and the siren light will stay on.
8. Press the 'Set' button once to turn the siren light off.  The siren has now been added to the alarm panel. 
9. You can now Arm the alarm and trigger a sensor to test the wireless siren.
   Click here to watch video: How to add a UK Wireless Siren to the Gen 2