Are the Gen 2 PIR Motion Sensor Pet Friendly

Our current pet immune sensors feature a single detection pattern (beam), which means that a cat or dog coming within 6 feet of the motion sensor will trigger the alarm. Normally, pets under 15kg will not easily trigger the alarm, but if the pets moves too close to it, the alarm still can be triggered. However the Pet immune works well at farther distances.

Eventually  we will soon be releasing dual pattern motion sensors in the future. These new models will have one beam upright and one low to the ground. The low beam will have very low sensitivity, ensuring pets won't trigger the alarm whatsoever. However, we do not yet have an estimated release date for these new sensors.

In the meantime, please follow these steps to optimize the performance of your current sensors:

-Install sensors at 7 feet or higher.

-Tilt the motion sensor upwards to avoid unnecessary ground scanning.

-Ensure there’s nothing pets can climb on within 6-7 feet of the sensor, such as couches or pet trees.

-Additionally, arm the alarm system and call your cat across the room. Keep testing by angling the motion sensor slightly each time until the cat does not trigger the alarm.

Your understanding and cooperation are greatly appreciated. If you have any questions or need further assistance, please feel free to contact us.

Best regards,

Customer Service
OSI Go Direct

1. Adjust the Mounting Angle

• Tilt the sensor upward: Most PIR sensors detect motion within a conical field. By tilting the sensor slightly upward, it will focus more on areas where a human would move rather than closer to the ground where your dog is active.
• Install it higher on the wall: Place the sensor higher than the manufacturer’s recommended height (e.g., 7–9 feet) to limit its range to areas above your dog's height.

2. Mask the Sensor

• Use tape or stickers to cover the lower part of the PIR sensor's lens, which will block it from detecting motion near the ground.
• Use opaque or frosted tape to selectively mask off sections of the lens to fine-tune its detection zone.

3. Position in a Narrow Field of View

• Aim the sensor to monitor a narrow, focused area like an entryway, rather than an entire room. This reduces the chances of your dog crossing the detection path.

4. Test Different Configurations

• Experiment with different heights, angles, and masking until you achieve a setup that reliably detects humans while ignoring your dog.