Help CenterAfter initialization you will need to re-add the sensors and wireless strobe alarm, etc. You can watch these easy to follow step-by-step Videos to re-add sensors / RFID Tags / Remotes and Wireless Siren. Each of these only takes a seconds to a minute to do.
Note: YOU WILL NOT HAVE TO RECONNECT WI-FI WHEN YOU REINITIALIZE
Connecting Contact Sensor from Smart Life App
Connecting Motion Sensor from Smart Life App
Connecting Remotes from Smart Life App
Connecting RFID Tags from Alarm Panel
Connecting Wireless Strobe Siren (if you have one) from Alarm Panel
Reset and Pair instructions have now been changed for new OSI Wireless Strobe Sirens purchased April 2022 and later. For those customers who purchased these sirens (whether separately or with the 14 Piece Kit), the instructions are still the same. This refers to when you press and hold the "Set" Button until you hear the following beeps to either Reset or Pair the Wireless strobe siren to the OSI Wifi Alarm System.
Important: Disconnect the wireless siren from the power adapter and turn the siren to the 'On' position.
Purchased April 2022 and Later - There is a 2-3 second delay between each beep
- 4 Beeps to Reset the Siren - After resetting turn the siren 'Off' then 'On'
- 3 Beeps to pair (learn) the Siren
- Please see video below. When you have finished adding the siren to the alarm panel, ensure that you plug the siren back into the power adapter. When it is plugged into the power adapter the on/off button is disabled.
Purchased FEB 2022 and Earlier - The beeps are one right after the other, faster.
- 3 Beeps to Reset the Siren - After resetting turn the siren 'Off' then 'On'
- 2 Beeps to pair (learn) the Siren
- Please see video below. When you have finished adding the siren to the alarm panel, ensure that you plug the siren back into the power adapter. When it is plugged into the power adapter the on/off button is disabled.